Mitsubishi Electronics router 60/60S Manual

PDF Manuals
559 Pages English

Mitsubishi Electronics router 60/60S
Pages
OF
559
Appendix 7.
Operation Messages on Setting and Display Unit
IV-26
Error No. Error message Details
E15 EDIT LOCK B
×
An operation (edit‚ input/output‚ buffer correction‚ etc.) inhibited
for machining program B was attempted.
E16 EDIT LOCK C
×
An operation (edit‚ input/output‚ buffer correction‚ etc.) inhibited
for machining program C was attempted.
E17 PARITY H ERR
×
A parity H error was detected during data input‚ etc.
Check the paper tape or input device. This error may occur if the
paper tape is dirtied with oil‚ etc.
E18 PARITY V ERR
×
A parity V error was detected during data input.
Check the paper tape to see whether the number of characters in
the significant information section of a block is odd.
Also check the state (cable wiring‚ noise measures‚ etc.) of the
connected equipment.
E20 OVER RUN ERR
×
• The control method using the DC codes‚ etc.‚ for the input/output
operation is incorrect.
Check the settings of the input/output unit parameters‚ and the
settings on the input/output unit side‚ and reset if necessary.
E21 PROGRAM
RUNNING
×
Deletion of a machining program was attempted during
operation.
Search was attempted during operation.
Change of data such as parameters was attempted during
operation.
Start of graphic check was attempted during operation.
• When using the two systems, the program being buffer corrected
was running with the other system.
Erasing or inputting (IC NC) of a program in the IC card being
used was attempted.
Formatting of the IC card was attempted during automatic start.
Accessing to the host computer was attempted during automatic
operation.
E22 CODE CHANGE
ERR
×
There was an illegal code on the paper tape.
Table of Contents
Expand All
Related Manuals for Mitsubishi Electronics router 60/60S