Seagate computer hardware ST1000NM0031 Manual

PDF Manuals
47 Pages English

Seagate computer hardware ST1000NM0031
CONSTELLATION ES SERIAL ATA PRODUCT MANUAL, REV. F 5
*One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting.
**During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels.
2.2 FORMATTED CAPACITY
Model
Formatted
capacity*
Guaranteed
sectors
Bytes per sector
ST2000NM0011
ST2000NM0031
ST2000NM0051
2TB 3,907,029,168
512
ST1000NM0011
ST1000NM0031
ST1000NM0051
1TB 1,953,525,168
ST500NM0011
ST500NM0031
ST500NM0051
500GB 976,773,168
*One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting.
2.2.1 LBA mode
When addressing these drives in LBA mode, all blocks (sectors) are consecutively numbered from 0 to n–1, where n is the number of
guaranteed sectors as defined above.
See Section 6.3.1, "Identify Device command" (words 60-61 and 100-103) for additional information about 48-bit addressing support of
drives with capacities over 137GB.
Relative humidity 5% to 90% (operating)
5% to 95% (nonoperating)
Relative humidity gradient 30% per hour max
Altitude, operating –60.96 m to 3,048 m
(–200 ft to 10,000+ ft)
Altitude, nonoperating
(below mean sea level, max)
–60.96 m to 12,192 m
(–200 ft to 40,000+ ft)
Operational Shock (max at 2 ms) Read 70 Gs / Write 40 Gs
Non-Operational Shock (max at 2 ms) 300 Gs 350 Gs
Vibration, operating 5–22 Hz: 0.25 Gs, Limited displacement
22–350 Hz: 0.50 Gs
350–500 Hz: 0.25 Gs
Operation Rotational vibration 20–1500Hz: 12.5 rads/s²
Vibration, nonoperating 10–500 Hz: 4.9 Grms ref
Drive acoustics, sound power (bels)
Idle** 2.7 (typical)
2.9 (max)
2.2 (typical)
2.5 (max)
1.9 (typical)
2.3 (max)
Performance seek 3.0 (typical)
3.3 (max)
2.8 (typical)
3.1 (max)
2.7 (typical)
3.0 (max)
Nonrecoverable read errors 1 sector per 10
15
bits read
Annualized Failure Rate (AFR) 0.73% based on 8760 POH
Warranty To determine the warranty for a specific drive, use a web browser to access the following
web page: http://www.seagate.com/support/warranty-and-returns/
You will be asked to provide the drive serial number, model number (or part number) and
country of purchase. After submitting this information, the system will display the warranty
information for your drive.
Load-unload cycles 300,000 (25°C, 50% rel. humidity) (600,000 design life testing)
Supports Hotplug operation per
Serial ATA Revision 2.6 specification
Yes
Drive specification ST2000NM0011
ST2000NM0031
ST2000NM0051
ST1000NM0011
ST1000NM0031
ST1000NM0051
ST500NM0011
ST500NM0031
ST500NM0051
Table of Contents
Expand All
Related Manuals for Seagate computer hardware ST1000NM0031