User Manual Toshiba Remote Starter Vf010H05 [74/106 Pages]

Toshiba remote starter VF010H05

100

101

102

103

104

105

106

JKSSS+ Series - 68

JKSSS+ Series 2.3 - 4.2KV

   Sets the value

in the thermal register which represents a

motor running at the nameplate current (with

no overheating or negative sequence currents

present).

•  Use the

data from the motor manufacturer’s specications.

When RTDs are used, this setpoint will be the

base point for the RTD biasing of the Thermal

  Use the data

from the motor manufacturer’s specications. This

setpoint denes the operating temperature rise of

the motor at full load amps or 100% load.

   This represents

the maximum temperature the stator insulation

will withstand. The user may choose to use

the temperature setting of the insulation class

(selected in Setpoint Page 1) or enter a specic

maximum temperature. This value should not

exceed the stator’s insulation temperature. This

maximum temperature represents 100% thermal

capacity.

   Always enabled.

It allows the soft starter to use the line current

imbalance information to bias the Thermal

  When the setpoint

is set to ON the controller will calculate the k

constant factor for biasing the thermal register, or

the user may choose to assign the k value.

  Allows

the level three password user to clear the thermal

SP.12SystemSetpoints(SetpointPage12)

(SecurityLevel:3)

  This setpoint group

allows the user to choose the default screen the

soft starter displays while the motor is running.

Select the metering page number (1-3), then

select the metering screen number. The range

varies depending on the selected page. To display

a default screen, program the following two

setpoints:

  : Range is Page 1 - 3.

  : If Page 1 is selected

as the default page, then Screens 1- 10 are

available. If Page 2, Screens 1-29 are available.

If Page 3 is selected, then Screens 1-6 are

available. (See Metering Menu, MP.1, for screen

number assignment.)

  Congures the RTD failure alarm and the

thermal register alarm.

   If enabled, and an RTD

shorts or open, an alarm occurs.

   Sets a level in the

thermal register to generate an alarm when the

Thermal Register Capacity Used has exceeded

this level.

   The amount of time that

the Thermal Register Used must exceed the

setpoint before an alarm condition will occur.

  This

setpoint group will congure the thermal register

and indicate to the soft starter which inputs to use

when thermal modeling.

  Enter the time from the motor

manufacturer’s specication sheet or use the time

dened by the OL Class. This setpoint is used to

dene the thermal capacity of the motor.

  Enter the amount of time

specied by the motor manufacturer or use half of

the time dened by the OL Class.

  : The time the motor

requires to cool down after it has stopped. Use

only the data provided by the motor manufacturer.

This setpoint is used to congure the cooling rate

of the thermal register.

   The amount of

time the motor requires for cooling down while

running. Use only the data provided by the motor

manufacturer.

   When RTDs are

used, the soft starter can be congured to use the

measured cool rates from the RTDs instead of the

programmed settings. This setpoint should only be

enabled when RTDs are present.

manualsocean.nz

Info

Toshiba remote starter ME00070B

Toshiba remote starter 18 - 1250 A

Toshiba remote starter 48-1250 A

manualsocean.nz

Info